江苏春晨电缆有限公司

JEM电机引接线JEM电机引出线JEM电缆

价格:10 2024-11-02 10:00:01 2133次浏览

江苏春晨电缆有限公司生产JEM电机引接线JEM电机引出线JEM电缆,

无功补偿如何提高功率因素

How to improve power factors by reactive power compensation

无功补偿如何提高功率因素首先了解什么是功率因数?功率因数:是用来衡量用电设备(系列用电设备,电网的变压器、传输线路,等等)的用电效率的数据。功率因数的定义公式:功率因数=有功功率/视在功率。有功功率:是设备消耗了的,转换为其他 ...JEM电机引接线JEM电机引出线JEM电缆

How to improve the power factor of reactive power compensation is to know what power factor and power factor first. It's a data to measure the electricity efficiency of electrical equipment (series of electrical equipment, power transformers, transmission lines, etc.). The definition formula of the power factor: the power factor = the active power / the view in the power. Active power: the equipment is consumed, converted to other...

2017-10-28 07:15

2017-10-28 07:15

刀开关的图形符号和文字符号

The graphic symbols and characters of the knife switch

刀开关的图形符号和文字符号刀开关的图形符号和文字符号如图所示。图 刀开关的图形符号和文字符号

The graphic symbols of the knife switch and the graphic symbols and character symbols of the word symbol knife switch are shown as shown in the diagram. Graphic symbols and literal symbols of a knife switch

2017-10-28 07:08

2017-10-28 07:08

如何计算变压器铁芯截面积

How to calculate the intercepting area of transformer core

如何计算变压器铁芯截面积小型单相变压器多采用壳式铁芯,变压器铁芯截面积与变压器的容量有关,一般按下列经验公式计算。 A=k√s(cm2)式中,s为变压器的容量;k为系数。硅钢片的k值见表。表 铁芯净截面系数的经验数据根据计算得到的A值,可 ...JEM电机引接线JEM电机引出线JEM电缆

How to calculate the cross-sectional area of transformer core is mainly used in small single-phase transformers. The core area of transformer is related to the capacity of transformer. It is usually calculated according to the following empirical formula. A=k root s (cm2) type, s for transformer capacity; K coefficient. The K value of silicon steel sheet is shown in the table. The empirical data of the net section coefficient of the iron core can be calculated according to the calculated A value.

2017-10-28 07:05

2017-10-28 07:05

变压器的基本结构和工作原理

Basic structure and working principle of transformer

变压器的基本结构是由铁芯和绕组(线圈)组成的。变压器铁芯是由两面涂有绝缘漆的硅钢片叠装而成的。绕组是绕在铁芯上的两个匝数不等的线圈,与电源相连的绕组称为一次绕组,与负载相连的绕组称为二次绕组。变压器就 ...

The basic structure of a transformer consists of a core and a winding (coil). The iron core of the transformer is made up of two silicon steel sheets coated with insulating varnish. A winding is a coil of two turns around an iron core. The winding connected to the power is called a primary winding, and the winding connected to the load is called the two winding. The transformer is...

店铺已到期,升级请联系 15923987592
联系我们一键拨号18951262418