北京桑普高能科技有限公司

公司简介

汽车座椅加热系统 car seat heating system

一 综合说明 General information

此款产品是我们多年研究的结晶,在控制方面采用微电脑控制,温度任意调节,同时有30分钟定时功能.组成更为简单,只有两部分,由插到点烟器上的控制器和连体热片组成.发热部分采用高科技发热材料,升温快. This product is the result of our effort on researching and developing through many years, the control system is controlled by the micro-computer, the temperature is adjusting freely, with 30minutes timing function. The product is made by only two sections, the controller which is plug in to the cigarette-plug plus pads, the heating element is adopted by hi-tech heating material, with the character of temperature raising rapidly.

二 是您冬季的好伴侣 your best companion in winter season

在每年寒冷的冬季,它升温快,温度任意调节,使您的腰酸腿疼有一定的缓解作用,对健康者-有一定的保健作用,可避免因寒风的入侵所引发的疼痛.in every cold winter, this product will reducing your painful of your waist and back through its rapidly temperature-raising and temperature-adjusting, it healthy to the people, to live away from the painful caused by cold wind.

三 安装方法installation guide

1.将座椅的外座套取下,而后将发热片的背面双面胶撕开,再将发热片粘贴到座和靠背上,再把座套套好.贴热片时座和靠背粘贴时要成直角take out the outer cover of the seat, tear off the double-side sticky, stick the heating pad into the bottom and back from the seat, then re-cover the seat cover, it should be a 90degree angle while sticking the bottom and back

2.将加热体的电极引出线从座和靠背的中缝处放于座椅下面.put the extend wire from electrode at the bottom of the seat where the position of the seat and back

3.将温度控制器插到汽车点烟器的插座中.而后将控制器的插头和发热体的插座在座椅下方对接,这时座椅加温系统就安装好了.plug the temperature controller into the cigarette-plug, to connect the connector of controller with the connector of the heating pads under the seat, then the whole heating system is installed well.

四 使用方法users manual

1.将温度控制器的开关从细的符号方向向粗符号方旋转,这时电源灯和调温灯同时亮,红灯为升温工作灯,绿灯为电源灯.turn the switch of the temperature controller from thin-sign to the thick-sign, the indicator of power and temperature-adjusting will be light-on at the same time, the red-indicator mean temperature raising indicator, the green-indicator means power indicator.

2.调温开关上的温度指示符号越粗表示温度越高.即向粗符号方向旋转到某一位置不动后,表示把温度设定在此点上.the changes of thicker-sign of temperature indicator from temperature adjusting switch means raising the temperature steadily, the temperature will be set up wile you turn the switch to the thicker-sign and stay in a certain position.

3.如果在使用一段时间后发现温度较高,这时可向细符号方向旋转,将温度设定低一些.if you feel the temperature is higher after you using it for a certain time, to reduce the set up temperature by turning the switch to the thinner-sign.

4.如果要关掉加热系统,只需将调温开关旋到温度调节符号小处后即可,这时控制器上的灯全部灭掉.if you want switch off the heating system, just turn the temperature adjusting switch into the minimize of the sign, the indicator from the controller will be off at this time.

产品信息

店铺已到期,升级请联系 13430521128
联系我们一键拨号13021243672